pythonkisses
Well-Known Member
PRODUCT INFORMATION FOR P375
ALARM SYSTEM
Contents of kit
Introduction
This Australian Standards approved immobiliser alarm provides two circuits of engine immobilisation operated by rolling code random encrypted remote control. Entry point protection of doors, boot and bonnet with an intelligent glass break sensor. Audible warning is achieved via a standard 115dB siren, visually via the vehicle indicators and via a dash mounted high intensity red LED. The system may provide keyless entry.
Proudly Australian
Designed and engineered in Perth, Western Australia.
Operation
Arming procedure while ignition is off
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active .
Disarming procedure
The system will disarm when the main button of a valid remote control is pressed.
Auto Arming feature
The immobiliser will automatically immobilise the engine 39 seconds after the engine has stopped, if the vehicle is left untouched.
Immobilisation
Two independent circuits of immobilisation
30 Amp rated, normally open contacts.
Automatic immobilisation
39 seconds after ignition switch is turned off.
Safety circuitry incase of power failure
System sources alternate power from ignition if main power is lost.
Third circuit of immobilisation (optional)
Additional immobilisation circuits can be added to conform with insurance company requirements .
On-board relays
Protection against harsh road conditions
All relays are fully encapsulated to provide protection against dust and moisture.
Controllers
Two polycarbonate remote controls
Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal.
Weather proof case
Both halves of the case are sealed by a silicon membrane.
Large system memory
Allows system to track three controllers.
Controller re-programming
Service technician can delete lost or stolen controllers from memory.
Compatible Remotes
This system comes standard withREM-015 but is compatible with REM-014
Remote battery life
The 27a 12 volt 20mAH alkaline battery has a expected average life span of between 6 and 12 months (depending on usage). Battery manufacturer may vary due to availability of stock.
Wiring
Security wiring
All cables extending from the module are black and same diameter.
Plug and play for service
Designed to allow easy access for service technicians.
Security housing
Connector plug is enclosed within module case to prevent access by thief.
Stealth wiring
Cutting any immobilisation wiring will still leave the car secure.
Override
Emergency Personal Identification Number override
Enter the secret four digits to override the immobiliser .
Alterable PIN
Users can change the numbers of their secret override PIN .
One shot override
Immobiliser always re-arms to protect vehicle, re-enter PIN if vehicle needs to be driven after auto-arming has occurred
PIN card
Secret override PIN is supplied on handy 90mm x 50mm card.
Visual Output
Super bright red dash LED
This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window.
Arm/Disarm confirmation
System flashes car indicators when arming or disarming.
Alarm illumination
System flashes car indicators when thief triggers alarm.
Audio Output
Mini battery backup siren
Siren sounds even if battery terminals are disconnected from vehicle battery.
Standard siren
AS/NZS 3749.1:2003 Class B approved 115dB siren.
Negative siren output
Can be used to trigger car horn relay or siren.
Arm/Disarm confirmation
System sounds a siren when arming and disarming .
Temporary arm/disarm chirp disable
Momentarily press the second button of the remote control before pressing the main button, the siren will not chirp during that one operation.
Intrusion Detection
Doors, bonnet and boot monitoring
Triggers alarm system if intruder opens any protected entry point in vehicle .
Audio glass breakage detectionUses the sound of the breaking glass to trigger (not vibration) Accepts plug-in Ultra-sonic sensor
Sensor produces a 40KHz sound wave and measures echo to detect intruder,
Accepts plug-in single zone microwave sensor
Sensor produces a microwave field to detect intruder,
Accepts plug-in dual zone microwave sensor
Sensor produces two microwave fields, exterior field to sound siren as warning, interior to trigger alarm in full,
Accepts plug-in single stage shock sensorSensor measures vibration subjected to vehicle to detect intruder, Accepts plug-in two stage shock sensor
Sensor measures two levels of shock, soft shock to sound siren as warning, heavy shock to trigger alarm in full,Compatible with tilt sensorSensor measures vehicle angle with respect to earth, triggers if angle changes - no response to vibration
Central Locking
Locks and unlocks all doors
System can trigger factory central locking, aftermarket central locking or central locking relays .
Variable pulse time
Extend pulse length to drive pneumatic central locking systems (Mercedes) .
Automatic re-locking
System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed .
Anti-hijacking protection
System locks doors when ignition is turned on, unlocks when ignition is turned off .
Dual stage unlock
Allows user to unlock driver's door before unlocking all other doors .
Specifications
Current draw
<10mA average while armed
<250mA disarm (and for no more than 39 seconds after ignition is switched off).
Operating voltage
Operating voltage +9VDC to +15VDC.
Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin.
Operating temperature
-20 degrees to +105 degrees for equipment designed to be installed inside engine compartment.
Polarity protection
Accidentally reversing the battery leads will not damage the system.
Independent indicator power fuse
System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation.
Short circuit protection
Fuse protected in case any high power wiring is sheared through and shorted circuited.
Convenience Functions
Panic / Car Finder
Press and hold second button of remote control to cause siren to sound and indicators to flash.
Electric window closer
Provides signals used by electric window closers, system will close all electric windows when armed by remote control .
Courtesy light switch activation
System switches courtesy light on for 30 seconds or until ignition switch is turned on, when disarmed .
Electronic boot release
Press and hold the secondary remote control button, while system is disarmed, to activate boot release output. The indicators will flash four time each time the boot release signal is sent
THIS IS BRAND NEW NEVER USED BOX HAS BEEN OPENED TO CHECK EVERYTHING IS IN THE BOX BEFORE LISTING ON HERE
250
ALARM SYSTEM
Contents of kit
Introduction
This Australian Standards approved immobiliser alarm provides two circuits of engine immobilisation operated by rolling code random encrypted remote control. Entry point protection of doors, boot and bonnet with an intelligent glass break sensor. Audible warning is achieved via a standard 115dB siren, visually via the vehicle indicators and via a dash mounted high intensity red LED. The system may provide keyless entry.
Proudly Australian
Designed and engineered in Perth, Western Australia.
Operation
Arming procedure while ignition is off
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active .
Disarming procedure
The system will disarm when the main button of a valid remote control is pressed.
Auto Arming feature
The immobiliser will automatically immobilise the engine 39 seconds after the engine has stopped, if the vehicle is left untouched.
Immobilisation
Two independent circuits of immobilisation
30 Amp rated, normally open contacts.
Automatic immobilisation
39 seconds after ignition switch is turned off.
Safety circuitry incase of power failure
System sources alternate power from ignition if main power is lost.
Third circuit of immobilisation (optional)
Additional immobilisation circuits can be added to conform with insurance company requirements .
On-board relays
Protection against harsh road conditions
All relays are fully encapsulated to provide protection against dust and moisture.
Controllers
Two polycarbonate remote controls
Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal.
Weather proof case
Both halves of the case are sealed by a silicon membrane.
Large system memory
Allows system to track three controllers.
Controller re-programming
Service technician can delete lost or stolen controllers from memory.
Compatible Remotes
This system comes standard withREM-015 but is compatible with REM-014
Remote battery life
The 27a 12 volt 20mAH alkaline battery has a expected average life span of between 6 and 12 months (depending on usage). Battery manufacturer may vary due to availability of stock.
Wiring
Security wiring
All cables extending from the module are black and same diameter.
Plug and play for service
Designed to allow easy access for service technicians.
Security housing
Connector plug is enclosed within module case to prevent access by thief.
Stealth wiring
Cutting any immobilisation wiring will still leave the car secure.
Override
Emergency Personal Identification Number override
Enter the secret four digits to override the immobiliser .
Alterable PIN
Users can change the numbers of their secret override PIN .
One shot override
Immobiliser always re-arms to protect vehicle, re-enter PIN if vehicle needs to be driven after auto-arming has occurred
PIN card
Secret override PIN is supplied on handy 90mm x 50mm card.
Visual Output
Super bright red dash LED
This LED flashes to inform user when system is armed. The LED is mounted on the driver's side dash and is visible from outside the window.
Arm/Disarm confirmation
System flashes car indicators when arming or disarming.
Alarm illumination
System flashes car indicators when thief triggers alarm.
Audio Output
Mini battery backup siren
Siren sounds even if battery terminals are disconnected from vehicle battery.
Standard siren
AS/NZS 3749.1:2003 Class B approved 115dB siren.
Negative siren output
Can be used to trigger car horn relay or siren.
Arm/Disarm confirmation
System sounds a siren when arming and disarming .
Temporary arm/disarm chirp disable
Momentarily press the second button of the remote control before pressing the main button, the siren will not chirp during that one operation.
Intrusion Detection
Doors, bonnet and boot monitoring
Triggers alarm system if intruder opens any protected entry point in vehicle .
Audio glass breakage detectionUses the sound of the breaking glass to trigger (not vibration) Accepts plug-in Ultra-sonic sensor
Sensor produces a 40KHz sound wave and measures echo to detect intruder,
Accepts plug-in single zone microwave sensor
Sensor produces a microwave field to detect intruder,
Accepts plug-in dual zone microwave sensor
Sensor produces two microwave fields, exterior field to sound siren as warning, interior to trigger alarm in full,
Accepts plug-in single stage shock sensorSensor measures vibration subjected to vehicle to detect intruder, Accepts plug-in two stage shock sensor
Sensor measures two levels of shock, soft shock to sound siren as warning, heavy shock to trigger alarm in full,Compatible with tilt sensorSensor measures vehicle angle with respect to earth, triggers if angle changes - no response to vibration
Central Locking
Locks and unlocks all doors
System can trigger factory central locking, aftermarket central locking or central locking relays .
Variable pulse time
Extend pulse length to drive pneumatic central locking systems (Mercedes) .
Automatic re-locking
System will re-arm and re-lock doors if previously disarmed by remote control and doors remain closed .
Anti-hijacking protection
System locks doors when ignition is turned on, unlocks when ignition is turned off .
Dual stage unlock
Allows user to unlock driver's door before unlocking all other doors .
Specifications
Current draw
<10mA average while armed
<250mA disarm (and for no more than 39 seconds after ignition is switched off).
Operating voltage
Operating voltage +9VDC to +15VDC.
Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin.
Operating temperature
-20 degrees to +105 degrees for equipment designed to be installed inside engine compartment.
Polarity protection
Accidentally reversing the battery leads will not damage the system.
Independent indicator power fuse
System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation.
Short circuit protection
Fuse protected in case any high power wiring is sheared through and shorted circuited.
Convenience Functions
Panic / Car Finder
Press and hold second button of remote control to cause siren to sound and indicators to flash.
Electric window closer
Provides signals used by electric window closers, system will close all electric windows when armed by remote control .
Courtesy light switch activation
System switches courtesy light on for 30 seconds or until ignition switch is turned on, when disarmed .
Electronic boot release
Press and hold the secondary remote control button, while system is disarmed, to activate boot release output. The indicators will flash four time each time the boot release signal is sent
THIS IS BRAND NEW NEVER USED BOX HAS BEEN OPENED TO CHECK EVERYTHING IS IN THE BOX BEFORE LISTING ON HERE
250
